You may want to use some scrap stock between Clamp the receiver and fixture in a large vise so that theĮdge of the fixture inside the receiver is flush or just slightly above Place the fixture in the receiver, making sure it is tight against Radiused slightly so the fixture can be flush against the bottom of the Towards the center to angle the fixture and maintain the desired 1ĥ/8-inch size on the very end.
25-inch wide barĪnd a 5/8" block on the rear of the bar. Weld a 3/16" block to the front end of the 1. These are inside dimensions, not outside measurements. The AK receiver needs to beġ3/1h (1.187) inches at the front and 1% (1.625) inches at the rear. I welded small steel blocks to its ends to angle it to create theĬorrect front and rear inside dimensions. This fixture will be placed in the interior of the receiverĪnd the top rails gradually formed over it with a hammer. It will be made from a 101/4-inch piece of lx1 1/4-inchīar stock. An easy-to-make fixture will be used to bend these rails at theĬorrect height. Now that the bottom of the flat is bent, the top rails need to beįormed. This time, he forms the rails, installs the trunnions and trigger assembly and finishes the receiver. APA style: AK-HD building a heavy duty semi-auto AK-47 receiver part 2: in part 1 (1/20 issue), Matthews built a frame bending jig and bent his extra-thick AK receiver.This time, he forms the rails, installs the trunnions and trigger assembly and finishes the receiver." Retrieved from AK-HD building a heavy duty semi-auto AK-47 receiver part 2: in part 1 (1/20 issue), Matthews built a frame bending jig and bent his extra-thick AK receiver.
AK RIVET SIZES FREE
This time, he forms the rails, installs the trunnions and trigger assembly and finishes the receiver." The Free Library. MLA style: "AK-HD building a heavy duty semi-auto AK-47 receiver part 2: in part 1 (1/20 issue), Matthews built a frame bending jig and bent his extra-thick AK receiver.
0 kommentar(er)
